Proper Maintenance Measures and Methods for Various Commercial Kitchen Equipment

　　Daily maintenance measures for various commonly used kitchen equipment can significantly extend the lifespan of the devices—if you stick to these practices. Commercial kitchen equipment can only deliver its full potential when properly maintained, ultimately enhancing the cost-effectiveness of your kitchen setup. Below are maintenance tips and methods tailored for different types of commercial kitchen equipment.

　　1. Stove: Clean the iron frame and stainless steel tray on the stove daily, and regularly wash the natural gas burner nozzles.

　　2. Steam Cabinet: Clean the inner walls and shelves of the steam cabinet daily, and inspect the steam pipe valves and the natural gas-air mixing device every 15 days.

　　3. Dishwasher: Keep both the interior and exterior of the dishwasher clean daily. Perform an internal descaling every 30 days, and regularly check the usage of detergent and rinse aid to prevent foreign objects from causing blockages.

　　4. Grill: Clean the steel plates daily, regularly inspect and keep the natural gas nozzles of the grates clean. Adjust the natural gas nozzles and ignition device every 15 days.

　　5. Oven: Clean the oven's surface daily and check that all wiring is clear. Ensure the chain and switches remain properly connected to maintain efficient operation.

　　6. Deep Fryer: Clean the inner walls of the oil tank and the filter mesh daily. Adjust the natural gas nozzles and ignition device every 15 days. Also, inspect the oil drain system.

　　7. Refrigerator: Keep the inside and outside of the refrigerator clean daily, and defrost it once every 7 days. Regularly check the power supply and temperature control settings. Ensure the refrigerator compressor operates smoothly at all times.

　　8. The exhaust duct should be as short as possible, with the largest possible turning radius—this ensures smooth airflow, improves smoke extraction efficiency, and reduces noise levels.

　　9. Other kitchen equipment should be thoroughly cleaned after each use, regularly maintained, and have their gears and bearings oiled monthly. It’s best to have the motor inspected and serviced every three months.